Polos CH32VXX RISC-V Breakout Boards

-

 

Polos CH32VXX RISC-V Breakout Boards

CH32V Series MCUs are designed by Qinheng Microelectronics Co., Ltd., focuses on connectivity technology and microprocessor research and is an IC design company. CH32V Series MCUs are low-cost & powerful functions like BT, USB2.0/3.0, CAN, I2C, SPI, USB PD and so on. So we develop the Polos CH32Vxx RISC-V Breakout Boards. Qinheng Provide C/C++ SDK, Arduino Library, and MRS IDE. We perfer to use Embedded Rust, We will support Embedded Rust development in CH32Vxx RISC-V MCU.

Polos CH32V003 Breakout Alef - Features

  • Main Chip Type: CH32V003F4U6 with QFN20 Package
  • QingKe 32-bit RISC-V2A processor, Up to 48MHz frequency
  • 2KB SRAM, 16KB Flash, 3.3/5V Power Supply
  • 1 ch DMA, 1 group of OP Amp, 1 group of 10-bit ADC
  • 16 bit timer x 2
  • USARTx1, I2Cx1, SPIx1
  • 18 I/O ports, mapping an external interrupt
  • 64-bit chip unique ID
  • 1-wire serial debug interface (SDI)

Polos CH32V203F8 Breakout Alef - Features

  • Main Chip Type: CH32V203F8P6 with TSSOP20 Package
  • Qingke V4B, up to 144MHz frequency
  • 20KB SRAM, 64KB Flash, 3.3/2.5V Power Supply
  • Low-power modes: sleep/stop/standby
  • Down to 44.65uA/MHz in Run mode
  • Down to 17.90uA/MHz in Sleep mode
  • 1 x 18ch DMA, 2xOP Amps, 2 x 9ch 12-bit ADC
  • 1xUSB2.0 FS H/D
  • USARTx2, I2Cx1, SPIx1
  • 17 I/O ports, mapping 16 external interrupt
  • CRC calculation unit, 96-bit unique ID
  • Serial 2-wire debug interface

Polos CH32V305 Breakout Alef - Feautres

  • Main Chip Type: CH32V305FBP6 with TSSOP20 Package
  • Qingke V4F, up to 144MHz frequency
  • 32KB SRAM, 128KB Flash, 3.3/2.5V Power Supply
  • Low-power modes: sleep/stop/standby
  • 2 x 9ch DMA, 1x12 bit DAC, 2 x 1ch 12-bit ADC
  • 1xUSB2.0 HS H/D
  • USARTx2, I2Cx1, SPIx1
  • CANx1
  • Timerx8
  • Touch Key x1
  • 17 I/O ports, mapping 16 external interrupt
  • CRC calculation unit, 96-bit unique ID
  • Serial 2-wire debug interface

Comments

Post a Comment

Popular posts from this blog

Amnos CH347T Breakout

-
Image
  Amnos CH347T Breakout Overview Amnos CH347T Breakout is developed by XPU Labs, a subsidiary of AnalogLamb.Com. CH347 is a high speed USB converter interface chip, can provide USB to UART, I2C, SPI, JTAG, GPIO functions. Amnos CH347T Breakout's size is 40x40mm. It supports USB to two UARTs, It is used to program ESP32, integrate esp32 auto-download circuit. And it is used to program Xilinx FPGA with USB to JTAG function. It can also program EEPROM or Flash with USB to I2C/SPI function. Specifications USB2.0 high-speed device with a bandwidth of 480Mbps High-speed dual serial ports support up to 9Mbps baud rate Integrate ESP32 auto-download Function with USB to UART JTAG interface, 4-wire standard JTAG protocol, high-speed transmission, up to 60MHz Program Xilinx FPGA to RAM or FLASH with USB to JTAG I2C interface, can be used to operate EEPROM or various sensors SPI interface supports 2 chip selection signals, the highest frequency can reach 36MHz Several GPIOs can be used with US...
Read more

ALB32-WROVER - 64Mb Flash , 32Mb PSRAM ESP32-WROOM Module

-
Image
Pre-Order Now Hello, Welcome to AnalogLamb Blogger. AnalogLamb is a online shop for ESP32 Modules & Boards, IoT Application Kits. We are glad to sharing our ideas, R&D process and lessons or experience we get. Today I will introduce our new ESP32 modules - ALB32-WROVER. What is the Features - ALB32-WROVER? ESP32 Wi-Fi and Bluetooth combo chip inside. 64Mb Flash 32Mb PSRAM Pins to Pins Compatible with  ESP-WROOM-32 completely Community Education Module Size: 18 x 25 x 3 mm It is the top side of ALB32-WROVER module. You have noted that. We can use the shield of  ESP-WROOM-32(only has 32Mb Flash). But It has 64Mb Flash, 32Mb PSRAM. It is very easy to mount it on any  ESP-WROOM-32 board. It is the bottom side of ALB32-WROVER module. The Pins and dimension are same with  ESP-WROOM-32 Completely. Now we are testing the module. And Plan to release  ALB32-WROVER module on Aug. 2017. You can pre-order it now. ...
Read more